Continued on with insulation today, just had a little bit of the ceiling to do, but the most of the installation was for the walls. For this, we used R2.2 wall pads made from polyester (like the ceiling ones). It comes in 580x1160mm pre cut pads that are 90mm thick. These were cut in the same way as the ceiling ones were, with sections cut out to accommodate any wiring or pipes. Yesterday we had some of the boys help us out from the other house, so Rich had us go over a few of these as there were a few gaps present that he wanted closed up.
This got all finished up today, so we cleaned up the window frames by cutting back the expandable foam & also just gave the interior a sweep out preparation for the delivery of the gib sheets that came today.
Some of us were outside doing the rest of the weatherboards that are left to do. We didn't quite get it done, but it should be finished up easily by tomorrow as there is only a couple of runs to go.
thanks again for your work Kim, awesome as always,
ReplyDeletecant really add to your postings as you've covered most things comprehensively